Huawei h35-560 practice test

Which of the following functions is used for inter-cell interference coordination?

• A. ANR
• B. ICIC
• C. BF
• D. AMR

In single-site verification, within the visible target coverage area of ​​the base station, which of the
following principles should be met for the RSRP compliance rate of the test road?

• A. The probability that F band meets RSRP> -HOdBm and RS-SINR> -3dB is greater than 98%; D band is greater than 90%
• B. The probability that F band meets RSRP> -105dBm and RS-SINR> -3dB is greater than 98%; D band is greater than 90%
• C. The probability that F band meets RSRP> -lOOdBm and RS-SINR> -3dB is greater than 98%; D band is greater than 90% ・
• D. The probability that F band meets RSRP> -95dBm and RS-SINR > 3dB is greater than 98%; D band is greater than 90%

The single-site verification test only needs to verify whether the cell status is normal in the idle
mode.

• A. True
• B. False

Which of the following is not a weak coverage solution?

• A. adjusteNodeBTransmit power
• B. Adjust the antenna azimuth and downtilt angle, increase the antenna height, and replace the high- altitude wire, etc.
• C. Adjust neighbor relations
• D. Check whether the room sub-system or repeater is working normally, and check whether there is other radio interference

What are the principles that need to be followed when planning LTE neighboring cells? (Multiple
choice)

• A. Neighborhoods that are directly adjacent to the geographic location are generally regarded as neighboring cells
• B. For dense urban areas and ordinary urban areas, due to the relatively close distance between stations (0.3-1.0 km), neighbouring areas should do more
• C. Because there are no sequential I and possible questions in LTE neighboring cells, and the detection period is very short, it is only necessary to consider not missing neighboring cells, and it is not necessary to sort neighboring cells strictly according to signal strength.
• D. Turn on ANR to completely replace the neighborhood planning of the initial network

Which of the following results can be reported in the Measurement Report? (Multiple choice)

• A. RSRP
• B. SINR
• C. RSSI
• D. RSRQ

Which of the following types of warm wires are commonly used? (multiple choices)
〃

• A. 1/2 Feeder 〃
• B. 1/3 Feeder 〃
• C. 7/8 Feeder 〃
• D. 5/4 Feeder

What are the wireless indicators that need to be paid attention to during the drive test? (multiple
choices)

• A. Up and Downmcs
• B. RSRP&RSRQ&RSSI&SINR
• C. BLER&rate
• D. Ec/Io

The uplink interference problem is judged by checking the RSRP of each cell.

• A. True
• B. False

The main work content of single site verification includes: site verification configuration, site
coverage verification, site business verification and handover relationship optimization.

• A. True
• B. False