Huawei h31-311-v2-5 practice test

When configuring the SXCS single board for the OSN3500, which of the following is the access
package of the fully configured substand?

• A. 35G B.58.75G
• C. 80G
• D. 156 to pick up the answer

When configuring LMSP, there are two switching modes: single-ended switching and double-ended
switching. Single-ended switching does not require the protection protocol to be enabled.

• A. True
• B. False

Which of the following statements about the OTM-n .m and OTMnr .m for OTN are incorrect?

• A. n represents the number of wavelengths carried by the maximum capacity
• B. m indicates the rate. The value can be 1, 2, or 3. .
• C. r represents OTM., which does not have OSC capabilities
• D. OTM-nr .m with OSC signal is OTM-n.m.

Which of the following statements regarding multiplexing partial remote False indication (MS-REI) is
correct?
(1) B2 bytes indicate the transmission channel.
(2) The M1 byte represents the transmission channel
(3) THE MS-REl is sent from the receiver to the source.
(4) MS-REI is transmitted from the source to the receiver.
(5) Indicates the number of bit Falses detected by the receiver after receiving the MS signal.
①④⑤
②④⑤
A.
①③⑤
B.
C.
D. (2) (3) (5)

Which of the following is the frame indicated by the VC-4 J1 byte by the AU pointer of the current
frame?

• A. Current framework
• B. Next frame
• C. Previous frame
• D. None of the above

QinQ technology can be used when multiple users need to share the same VCTRUK and use the same
VLAN ID.

• A. True
• B. False

Which of the following statements regarding the protection of the cross-connecting plate 1+1 is
correct? (Multiple choice).

• A. The source business board sends services to the main and standby crossover boards. .
• B. After the service cross-connection is completed, the active and standby cross-board sends the data of the primary cross-board to the receiving service board.
• C. The receiving service board can only receive data from the active cross-link board
• D. The bus of the two cross-connected modules works independently and does not interfere with each other. .
• E. Dual bus system structure indicates that the service board performs dual data transfer to the cross- connection side and selectively receives data on the cross-connection side. .
• F. Both cross-connecting plates have the same configuration. The service board will selectively receive services from one of them based on the quality of service and the status of the cross- connecting board. .

In WDM systems, it is ideal to use a dielectric thin problem filter (TFF) when using less than ()
wavelengths.

• A. 4
• B. 8
• C. 16
• D. 20

According to the formula "ODUk rate = 239/(239k) x STM-N frame rate", ODU4 The rate is equal to
the 239/235xSTM-N Pa rate.

• A. True
• B. False

Linear MSP (LMSP) has two modes: 1+1 and 1:1. Additional services can only be configured for the
protection channel in 1:1 mode of the LMSP.

• A. True
• B. False