hitachi hqt-4180 practice test

What are two consequences when a “New Installation” procedure is performed on a VSP Midrange
system? (Choose two.)

• A. The SVP drive is formatted.
• B. The MPC software is updated.
• C. All the data on RAID groups is lost.
• D. The license keys are deleted.

Which program is used to perform the “New Installation” procedure on a VSP midrange system?

• A. MPC
• B. Webconsole
• C. GUM
• D. BECK

Which two tools are available to configure NTP server settings on a VSP E590 system? (Choose two.)

• A. Storage Navigator
• B. Maintenance Utility
• C. Initial Setup Wizard
• D. HSA Embedded

You are installing a new VSP G700 and are using the Initial Setup Wizard (ISW) for the network
configuration.
Which set of IP addresses is configured with the ISW?

• A. IP addresses of maintenance ports
• B. IP addresses of management ports
• C. IP addresses of all the ports
• D. IP addresses of all the ports and of the SVP

You are installing a VSP F370 and you need to connect your laptop to one of the controllers.
What are the two default IP addresses of the maintenance ports of CTL1 and CTL2? (Choose two.)

• A. 10.0.0.17
• B. 10.0.0.16
• C. 192.168.0.17
• D. 192.168.0.16

Which tool do you use to install license keys on a VSP G370 system?

• A. HSA Embedded
• B. MPC Software
• C. Storage Navigator
• D. Maintenance Utility

Which program is used to perform the “New Installation” procedure on a VSP F700 system?

• A. raidcom CLI
• B. Hitachi Ops Center Administrator
• C. SVP Web console
• D. MPC connected to the maintenance LAN port

You need to replace a broken disk drive on a VSP G700.
What are two prerequisites? (Choose two.)

• A. You must use the Replace button in the Maintenance Utility before removing the drive.
• B. You must wear a wrist strap for ESD protection.
• C. The red LED on the drive must be lit.
• D. The Drive Box where the drive is located must be powered down.

You need to replace a broken fan in a VSP E1090.
What is the correct procedure?

• A. Use the MPC for blocking the fan, then replace it.
• B. Use the Maintenance Utility for stopping the fan, then replace it.
• C. Remove the broken fan, then replace it.
• D. Use Storage Navigator for blocking the fan, then replace it.

You need to replace a failing power supply (PS) in a VSP E590.
What is the correct procedure?

• A. Check if the status of the PS is blocked, and if yes, then replace it directly.
• B. Use the Maintenance Utility for blocking the PS, then replace it.
• C. Use the Maintenance Utility for blocking the controller, then replace the PS.
• D. Use the MPC for blocking the PS, then replace it.